Jeep wrangler steering wheel shakes 40 mph

Why Does My Jeep Shake Violently When I Go Over 55 mph?

Imagine your reaction to cruising down the highway at 55 mph when the front end of your Jeep Wrangler starts to shimmy and shake violently. If the idea of this happening to you sounds frightening, you’re not alone. This situation has happened to Jeep owners across the country for years. In fact, the shake can be so bad that many Jeep owners have named it the Death Wobble, but to date, no actual deaths have been associated with the problem. Learn why Jeeps sometimes shake violently and how you should handle the Death Wobble if it happens to your Jeep.

Death Wobble Explained

In order to determine if your Jeep is suffering from the Death Wobble, you first need to understand how to recognize this condition. First and foremost, don’t confuse the shaking with the type of vibration you might feel if your tires are out of balance or with a shimmy that indicates a defective tire. If you aren’t sure whether or not you have this condition, you probably don’t.

The Death Wobble tends to occur when you hit a bump or round a curve while driving at highway speeds. When this happens, the shaking can become so violent that the whole front end of your Jeep feels like it’s moving around on the road.

Though it might seem like the front end of your Jeep is in danger of detaching, there’s no real threat of this happening. The shaking only goes away once you slow down, though, and it can easily happen again once you speed up.

Common Causes of This Condition

In some cases, the shaking is related to the height of your Jeep and can depend on whether your vehicle is at stock height or if it’s been lifted. In general, stock height Jeeps encounter the Death Wobble more often, but this condition can occur in both stock height and lifted Jeeps. No matter which type you drive, however, the Death Wobble can lead to serious accidents if you don’t take the appropriate steps to remedy the situation.

If you’ve lifted your Jeep more than three inches, the problem may lie in a misaligned drive shaft. When this happens, the increased angle of the driveshaft between the transfer case and the front axle tends to put excessive strain on the universal joints. Because the u-joints are no longer running parallel to each other, they aren’t properly synchronized. This, in turn, can lead to excess vibration.

The bulk of the vibration complaints, however, have come from owners of stock height Jeeps. In these cases, one of the most common causes of the Death Wobble appears to be the Jeep’s front track bar. While the bar itself isn’t really at fault, the bolts that hold it in place and the supporting bushings can cause the vehicle to vibrate and shake.

Myths Associated with the Death Wobble

It should come as no surprise that a condition known as the Death Wobble has several myths associated with it. If you’re concerned that your Jeep has this condition, it’s in your best interest to understand the myths before trying to get to the bottom of the problem. Once you get past the myths, it will be much easier to feel confident in your Jeep dealer’s ability to solve the condition permanently, leaving you and your Jeep to cruise smoothly down the highway.

Steering Stabilizer

One of the most common myths associated with Death Wobble concerns the vehicle’s steering stabilizer. Similar to a shock absorber, this device is designed to absorb the vibrations that you would otherwise feel in the steering wheel while driving on bumpy roads. The myth revolves around the idea that you can get rid of the shaking by replacing the stock unit with a much heavier duty aftermarket unit. In reality, if all of your Jeep’s steering components are installed properly and in good condition, you shouldn’t even need a steering stabilizer. Replacing the stock unit might help to mask the symptoms, but it definitely won’t solve the problem.

3 Front Wheel Alignment

Another supposed cause of this problem is too much toe-out on the front wheels, which suggests that the front wheels point too far outwards. Although Jeeps are made to operate in four-wheel drive, the alignment is set up as if they were rear-wheel drive vehicles. This means the front tires should be toed-in slightly. Some believe that setting the front end up with the tires toed-out can solve problems with shaking. Again, this might help to reduce the symptoms, but it isn’t a long-term solution. Realigning the wheels improperly can also lead to early tire wear and other issues, so it’s best not to go this route.

Why does my Jeep wobble at 40 mph?

Why does my steering wheel shake when I drive 40 mph?

Why is my Jeep Wrangler steering wheel shaking?

Why does my Jeep shake at 50 mph?